Heat shrink over the other dielectric grease again Gob dielectric grease over all entire splice Heat shrink over dielectric grease connection Heres what I do on underground connections:Ĭoat each connection in dielectric grease I get my splices from the local pump co., used for splicing submersible pumps. It is a lot better than the hardware stuff and well worth the extra money. I would however go to a good electrical supply house and get some shrink tube with the glue in it. I spliced some 00 aluminum main cable 10 plus years ago and it is still working well. Posted 15:24 (#2679826 - in reply to #2679776) Subject: RE: EpoxyĮpoxy splice is only way to keep moisture out The crimper splices should be copper, not aluminum. and I would do it that way and add - they make a mastic type black gooy tape and put that around the whole thing. and will turn out watertight and weatherproof?I can never decide if they are finished getting heated or not, but dont want to overdo it either. slide a shrink tube over each strand and cook them medium well done.and slide a large shrink tube over the whole cable right over the small shrink tubes and cook it till it looks like like leftovers fortten in the oven too long with my hand torch. Am I correct that I can go to hardware store and get bare 12 crimps and big and small shrink tubes, splice each strand with the same crimp tool I use for my wiring kit on the farm equipment. School Of Hard Knock - 13:29 Is that the same shrink tube for burrying wires as any other application?I have some 12-2 with a ground to splice and it needs to be spliced underground. I would solder instead of crimp the wires and put it in a water tight box with the shrink wraps inside. Is that the same shrink tube for burrying wires as any other application?I have some 12-2 with a ground to splice and it needs to be spliced underground. Right and wrong ways? Jump to page : 1 Now viewing page 1 For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.You are logged in as a guest. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. Not for consumer sale or use.ģM industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Contact customer service at 80 to request a certificate. Note: 3M products offered on a government contract that require country of origin representation must be certified by 3M Trade Compliance. Some products contain imported components. The designation that a product is Manufactured in the USA means the product undergoes substantial transformation in one of our U.S.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |